HP DesignJet T120 Einführende Informationen Seite 6

Front-panel error messages
If you see an error message that does not appear here, and you feel in doubt about the correct response, or if the
recommended action does not seem to solve the problem, contact HP Support.
Message or code
[Color] cartridge has expired
[Color] cartridge is low on ink
[Color] cartridge is very low on ink
Depleted cartridges must be replaced to resume
printing
One or more cartridges appear to be missing or
damaged
Paper jam
Paper width is smaller than the minimum size supported
by the selected paper source. Load cancelled.
Loaded paper is too wide. Manual unload required.
Paper too far from lateral load line. Please try again.
Please manually unload roll paper and try again.
Single sheet is loaded with too much skew. Press Eject
to unload paper.
The current job has been cancelled because the roll is
out of paper. Load the roll and send the job again.
You are printing a multipage job. Load another sheet
to continue printing or cancel the job.
Multi-sheet tray is out of paper. Load paper in multi-
sheet tray and press OK to continue printing or cancel
the job.
End of roll has been reached. It is not possible to load
the roll.
Missing or failed printhead
Used cartridges might not have enough ink to complete
startup. Open ink door to replace the cartridges.
Out of memory
4 Introductory Information
Recommendation
Replace the cartridge.
Ensure that you have a new cartridge of the same color
ready.
Ensure that you have a new cartridge of the same color
ready.
Replace the cartridges as needed.
Insert cartridges of the correct color as needed.
See the User's Guide.
Remove the paper and load paper of the correct size.
Remove the paper manually and load paper of the
correct size.
Remove and reload the paper.
Rewind the roll manually.
Remove and reload the paper.
Load a new roll.
Load another single sheet.
Load paper into the multi-sheet tray.
Load a new roll.
Remove and reinsert the same printhead, or try
cleaning the electrical connections. If necessary, insert
a new printhead.
Note: The error message does not permit returning to
the home screen to start the printhead replacement.
Instead, press .
Check the cartridge.
A new printhead has been inserted without a new set
of ink cartridges. Replace the cartridges not marked
as new.
cannot process the job, which will be discarded.
The printer cannot complete the job. Resend the job,
selecting Send job as bitmap
the Advanced tab, then Document options
features.
in the driver: go to
> Printer