Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
4.
Once charged, disconnect the charger from the mains socket first and then remove
the charger connector from the battery.
5.
Insert the charged battery back into the tool. Make sure it is correctly aligned and
clicks into place until you hear a click.
NOTE:
-
Allow the battery to fully charge before disconnecting it from the charger.
-
To extend the battery life, avoid leaving it connected to the charger for extended periods
once it is fully charged and store it in a cool, dry place when not in use.
-
Only use the supplied charger to recharge your tool. The use of any other charger may
damage the tool or create dangerous conditions.
-
Only use a charger when charging the battery.
-
Never attempt to open the charger or the tool. Neither the tool nor the battery contain user
serviceable parts inside. Contact the official Cecotec Technical Support Service.
-
Always replace the battery with a new (or freshly charged) battery when the performance
of the tool begins to decrease. Intense heat is extremely damaging to batteries; the more
heat generated, the faster the battery loses power. A battery that gets too hot may have
a short service life.
-
Never over-discharge the battery by repeated use of the tool after the performance of the
tool has decreased. Do not attempt to discharge the battery by continuously pressing the
power switch. When battery performance begins to decrease, stop the tool and recharge
the battery for optimum performance.
-
Charge the battery at room temperature between 50° F - 104° F (10° to 40° C). Store the
tool and battery where temperatures do not exceed 120 °F (49 °C). This is important to
prevent serious damage to the battery cells. The battery should be recharged when the
tool starts to operate slowly. When not in use, keep the battery away from other metal
objects such as paper clips, coins, keys, nails, screws or other metal objects that can make
a connection between one terminal and another. Short-circuiting the battery terminals
may cause sparks, burns or fire.
3.4.1 Fitting or removing the battery
1.
Insert the battery by placing it on the guide and gently push it into the battery holder
until it clicks.
2.
To remove the battery from the tool itself, press the battery release button and
remove the battery.
NOTE:
-
Always insert the battery all the way in.
-
When it is fully engaged, you will hear a click.
-
If the battery is not fully inserted and is loose, it could accidentally fall out and cause injury.
154
PERFECTSURFACE 2120 ROTATE
Werbung
