Scheppach PRB300 Originalbetriebsanleitung Seite 11

8 Assembly and operation
ATTENTION
Always make sure the product is fully assembled
before commissioning!
8.1 Inserting the spray tank (6) (Fig. 2)
1. Fill the spray tank (6) with a cleaning agent suitable
for textiles. Observe the respective manufacturer's in-
structions.
2. Fill the spray tank (6) to approx. 5 cm below the rim.
3. Insert the vacuum hose with suction ball (5) into the
spray tank (6) and screw the spray tank (6) into the
spray tank cap (7).
8.2 Connect the deep spot brush to the
wet and dry vacuum cleaner (Fig.
3)
Note:
The product may only be used in conjunction with wet and
dry vacuum cleaners. Only use the wet and dry vacuum
cleaner in wet-suction mode. Observe the respective
manufacturer's instructions.
Use with conventional household vacuum cleaners is not
possible.
1. Connect the wet and dry vacuum cleaner's vacuum
hose (A) with a diameter of 31.5 mm directly to the ex-
traction port (4) of the deep spot brush. Use the suc-
tion adapter (10) for smaller diameters.
8.3 Operation (Fig. 4)
1. Switch on the wet and dry vacuum cleaner.
2. Hold the deep spot brush by the handle (3) and guide
it onto the textile to be cleaned. The brushes (9)
should touch the textile.
3. Spray the cleaning agent onto the textile by pressing
the trigger lever (2).
4. Slowly pull the deep spot brush towards you. The
deep spot brush draws the dirt out of the textile
through the opening of the top cover (1).
5. Repeat the process until dirt is no longer being visibly
drawn out.
9 Cleaning
• For larger soiling, you can wipe the product with a
damp Cloths.
• We recommend that you clean the product directly af-
ter every use.
• Clean the product at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the product. Make sure that no water can pen-
etrate the product interior.
9.1 Clean the extraction port (4) and
the top cover (1) (Fig. 5)
1. Remove the top cover (1) as shown in Figure (5).
2. Clean the top cover (1) and the inside of the extraction
port (4) under running water.
10 Storage
Preparation for storage
1. Disconnect the product from the wet and dry vacuum
cleaner.
2. Empty the product completely.
Store the product and its accessories in a dark, dry and
frost-free place that is inaccessible to children.
The optimum storage temperature is between 5°C and
30˚C.
Store the product in its original packaging.
Cover the product to protect it from dust or moisture.
Store the operating manual with the product.
11 Disposal and recycling
Notes for packaging
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 11