Ronix RP-U100 Bedienungsanleitung Seite 19

- Connect the water supply hose to female coupler. Then connect to water
inlet of the washer. The supply hose must have an internal diameter of at
least 13mm and must be reinforced. Water supply must be at least equal to
the washer delivery capacity.
NOTE:
The machine is not suitable for connection to the potable water main.
WARNING!
The intake water temperature must not exceed 40. The water supply
must not exceed 0.7 MPa.
CAUTION:
The washer must only be used with clean water; use of unfiltered water
of corrosive chemicals will damage the washer.
- Push the motor switch to "OFF" position.
Check the electrical supply voltage and frequency (Volt/Hz) correspond to
those specified on the washer rating plate. If the power supply is correct,
you may now plug in the washer.
OPERATION
- Turn on the water supply tap fully.
- Release the safety lock then press the trigger for a few seconds to
17
User Manual