Electrical Shock Hazard; Mains Power Connection - Ronix Rp-U100 Bedienungsanleitung

equipment (e.g. Blinking of a lamp). If the MAINS IMPEDANCE Zmax
<0.335 OMH, such disturbances are not expected. (in case of need, you
may contact your local supply authority for further information.)
WARNING!

ELECTRICAL SHOCK HAZARD

Improper connection of the equipment grounding conductor can result
in a risk of electrical shock. Check with a qualified electrician or service
person if you are unsure if an outlet is properly grounded. DO NOT
modify the plug provided with the appliance to fit an outlet, have a
proper outlet installed by a qualified electrician.

MAINS POWER CONNECTION

The following should be observed when connecting the high pressure
washer to the electric installation:
- The electric installation shall be made by a certified electrician and
comply with IEC-364.
It is recommended that the electric supply to this appliance should
include either a residual current device that will interrupt the supply if
the leakage current to earth exceeds 30mA for 30ms.
IMPORTANT!
Only use water without any impurities. If there is a risk of running sands in the
inlet water (i.e. from your own well), an additional filter should be mounted.
- Safety devices
- The unloader valve can reduce pressure if it exceeds preset values.
the spray gun features a looking device. When the pawl is activated, the
spray gun cannot be operated.
- Thermal sensor
A thermal sensor protects the motor against overloading. Machine will
restart after a few minutes when the thermal sensor has cooled.
15
User Manual