Flight Phases - Multiplex wingstabi Betriebsanleitung

10. Flight phases

The WINGSTABI has 4 individually usable flight phases.
Flight phase off (Flight phase 1)
The WINGSTABI is switched off and forwards control commands directly from
the transmitter to the servos.
Damping mode (flight phase 2)
For normal flying. External influences such as crosswinds and landing are mini-
mized. Here we are referring to a type of "wind canceling" functionality.
Full Heading Hold (Flight phase 3)
For elaborate acrobatics. This mode can only be used to a limited extent during
landing and take-off, as it demands a certain level of experience in flying the
WINGSTABI. Stalls are often detected too late by the pilot here. The advantage
is that the model remains absolutely consistent even with heavy winds. What
makes the WINGSTABI special here is that control over the rudder is specially
optimised, thus ensuring a realistic airborne appearance.
Torque-rolls! (flight phase 4)
Extreme heading hold mode. This mode is unsuitable for normal flying. The
model would soar upwards.
How do you activate the fourth flight phase, which cannot be activated in
the standard configuration?
In the software, switch to the receiver settings window "assign fourth flight
phase". An additional channel with 2-stage switch must be assigned.
i
This switch is overriding and switches off your WINGSTABI when pressed
in flight phase 1. The previously assigned 3-stage switch for the flight
phases now switches between phases 2, 3 and 4.

33