Charging The Headphones - Apw Core Pro Anc Bedienungsanleitung

INSTRUCTIONS

Charging the headphones

Fully charge the headphones before using it for the first time.
Insert both headphones into the charging case. The LED light will glow red while the head-
phones charge. When the LED light turns white for 30 seconds, the headphones are charged.
Charging the charging case
Plug the cable into the USB-C port on the charging case. Plug the other end into a computer or
adapter (adapter not included; required parameters: 5 V / 1 A).
The LED light will glow red while the charging case is charges. When the LED light turns white,
the charging case is charged. Disconnect the charging cable from the headphones and the
computer or charger.
Note: When not using the headphones for longer periods, continue to charge both them and
the charging case regularly.
Pairing
When using for the first time:
After pairing, the headphones are set to about 50% volume from the factory depending on
your device. You can adjust the volume on your phone, or on the headphones themselves by
pressing them. These two volume settings are independent of each other.
Remove both headphones from the charging case and close it. The headphones will enter
pairing mode.
Turn on Bluetooth on your mobile device and start searching for available devices.
Select the APW Core PRO ANC headphone model from the list displayed. Pairing is automatic.
Re-pairing with an already paired device:
Remove both headphones from the charging case. The headset will automatically connect to
the most recently paired device.
8 ENGLISH