Chapter V Learn how to use it
4. WARNING: Do not over tighten straps when you are assembling your seat attachment to your
hoverboard. Ensure that the seat attachment is securely attached to the hoverboard. See below
diagram for correct ftting.
5. Your hoverkart should be properly installed onto your hoverboard as shown below.
EN
5.3 Protect function
During operation, if the system runs incorrectly or be illegally operated, the self-balancing
electric scooter will prompt operators in different ways like prohibit riding, alarm indicator lights,
buzzer alarm beeps intermittently. The system cannot enter self-balancing mode.
• When step on the self-balancing scooter, the pedal go forwards or backwards more than 10 degrees.
• The voltage of the battery is too low
.
• During charging.
• During operation, the pedal unturned and prohibit operation.
• Over speeding.
• The power is not enough.
• The self-balancing electric scooter shaking back and forth for more than 30 seconds.
• System enters into protection mode, alarm indicator lights, buzzer alarms of high frequency
.
• The platform goes forwards or backwards more than 35 degrees, the self-balancing electric scoo
ter will directly into the stop mode.
• Tire stall, two seconds later the self-balancing electric scooter enters power off mode.
• The battery voltage is lower than the protection value, 15 seconds later the self-balancing e
lectric scooter enters into power off mode.
• Continuing large current discharge (such as a long-time climbing a very steep slope), 15 seconds
later the self-balancing electric scooter enters into power off mode.
12