Product Installation and Disassembly
Installation of the floor brush
As shown in the picture, align the electric floor brush
with the extension tube connector and gently push it
in. When you hear the "click" sound, the installation is
complete.
(To remove, simply press the locking button shown
below and pull down).
Installation of metal pipes
Connect the machine to one end of the extended aluminum tube (hear a
click" to indicate successful installation) and the other end is connected to a
floor brush or other accessory (as shown in the picture) and can be used as
an upright vacuum cleaner. (Figure): or connect the machine to a floor brush
to clean floors, tiles or carpets, etc. It's hard to clean. (To disassemble, simply
press the locking button in the figure to pull it apart)
扁吸安装
Installation of the long flat nozzle
As shown in the picture, align the slit nozzle with the body connector and
gently push it in. When you hear a "click", the installation is complete (to
remove, simply press the locking button shown in the figure below and pull
down).
4
English
Installation, disassembly and use of products
Opening and closing the dust cup
Pull the button on the dust cup to open it. Tap the button on the dust cup
upward and the dust cup is loaded.
Get Started
①
After installing all parts, turn on the on/off
button at the handle and start the vacuum
cleaner (button in the picture).
Suction power adjustment
When the machine is turned on, it will be in
automatic mode. It will adjust the vacuuming
②
power according to the dust capacity. Touch
screen to adjust the suction power, and the
low display will show "MIN", "MID" and "MAX"
three suction power modes, the high level
display will show "AUTO", "MIN" and "MAX"
three suction power modes.
Charging status and
indicator light
③
Connect the power adapter to the
charging connector in the battery pack,
connect the power to start charging. (As
shown) There is a progress bar while
charging on the LED screen.
low gear
middle gear
high gear
AUTO
MIN
MAX
AUTO
English
5