Warning; Installation; Configuration For Local Pc; Configuring The Company Network - Selco Ri Xp Betriebsanweisung

1 WARNING

Prior to performing any operation on the machine, make sure that you have thoroughly read and understood the
contents of this manual. Do not perform modifications or maintenance operations which are not prescribed.
The electrical system must be made by skilled technicians with the specific professional and technical qualifica-
tions and in compliance with the regulations in force in the country where the equipment is installed.
Disconnect the power supply before every operation!

2 INSTALLATION

The RI XP robot interface is a device enabling communication between a Selco generator and PC. The device is able to commu-
nicate via digital signals, in both reception and transmission. The information is transferred to the welding generator via a specific
connection cable with CAN BUS protocol.

2.1 Configuration for local PC

Configure the PC's TCP/IP protocol (see the "Configuration" section).

2.2 Configuring the company network

PC configuration: not normally required.
17