Citel P8AX Serie Installationshinweise

INSTALLATION INSTRUCTIONS - NOTICE D'INSTALLATION
NOTICIA DE INSTALACIÓN - INSTALLATIONSHINWEISE
ISTRUZIONI PER L'INSTALLAZIONE
INSTRUCOES DE INSTALACAO - MONTÁŽNÍ NÁVOD
РУКОВОДСТВО ПО МОНТАЖУ - 安装指导书
P8AX
Installation
Earthing over BK-N2 Earthing over well grounded Panel
1 1
BK-N2
unprotected
protected
2 side 2
unprotected
cable shoe
side
3 3
additional
additional
grounding
grounding
measures
measures
are necessary
are necessary
if the panel is
if the BK-N2 is
poorly grounded
poorly grounded
unprotected area
Technical Data
2000 m max.
6500 ft max.
-40/+85°C max.
-40/+1°F max.
IP20
indoor use only
Un P peak
90 V 25 W
150 V 70 W
250 V 190 W
500 V 780 W
600 V 1100 W
800 V 2000 W
Earthing over cable shoe
1
well grounded
panel
pliers
hole for P8AX
2
protected
side side
3
mounting nut
protected area
P/N
Connect with system
press cable
shoe together
Application example
C
Tower Top
surge SPD
protection
device
earth distribution
Maintenance
1
GDT holder
GDT
2
Test
SPT 800KE
OVERVOLTAGE PROTECTORS TESTER
4,57
CITEL
v
GDT - Tester
"SPT 800KE"
Location
Protectors should be installed near the coaxiale entry
from exposed cable runs. Typical coaxiale entries from
exposed areas include:
A. Down leads into a building or cabinet from towers or
outdoor antennas.
B. Cable entry from other buildings or outside networks.
C. Antenna interface into transmitter or tower top
amplifiers, and transmitter or tower top amplifier down
leads.
For critical applications, an interior second protector near
the equipment to be protected is recommended in
addition to A or B.
example
A
EQUIP t
SPD
SPD
B
Spark over voltage (100V/s)
≤ 20%
+
-
> 20%
+
-
and replace
defective GDT