Assembly And Installation; Operation - Livarno Home 864-R Bedienungs- Und Sicherheitshinweise

If the product has any identifiable faults,
„
stop using it immediately�
RISK OF INJURY!
Incorrect handling of the product
may potentially result in personal
injury�
The light source may only be replaced by
„
the manufacturer, service technician or a
similarly qualified person.
Never look directly into the light source�
„
Do not connect the product to a power
„
source while still inside the packaging�
There is a risk of overheating!
WARNING! DO NOT USE THE LIGHT
„
CHAIN UNLESS ALL SEALING RINGS
HAVE BEEN PROPERLY MOUNTED.
The operating unit is intended exclusively for
use with LED modules�
The control gear of this product may only
„
be replaced by the manufacturer, its
designated service technician, or a similarly
qualified person.
TRIPPING HAZARD! Please make
sure that the power cable
routed in such a way that nobody
can tread on it or trip over it�
z Assembly and installation
Please note: Take the product out of its
packaging and remove all packing material�
Check that all package contents are
„
present�
Check if the product or individual parts are
„
damaged� Should you detect damage, do
not use the product� Please contact the
retailer via the service address indicated�
FIRE HAZARD!
Never hang the product above an
open fire or heat source. This may
damage the product and excessive heat
build-up can cause a fire.
Connect power supply
Fig� B)�
Tighten the union cap
„ „
thread of the connection socket
Plug the mains plug
„ „
has been correctly installed�
Please note: Only suitable for outdoor use
when the plug connected to mains power is
protected from the elements�
z Operation
Please note: Only use the product with the
is supplied mains plug� Do not connect the
2
product or the mains plug to any external
devices�
Please note: The product stays lit as long as
it is connected to the power supply� If you
unplug it, the product will automatically
switch off�
Timer function
To activate the timer function, keep the
„ „
button
down until the LED light turns green (see
Fig� C)� The timer has now been activated�
When the timer function is switched on, the
„ „
product is switched on for 6 hours and then
switched off for 18 hours�
RISK OF DAMAGE!
Take sufficient measures to secure
the product from falling down�
RISK OF ELECTRIC SHOCK!
Plug the connector
5
socket of the mains plug
6
on the screw
4
into a socket that
1
DANGER OF OVERHEATING! Do
not operate the product while it is
still inside the packaging!
on the mains plug
7
into the
(see
1
�
6
pressed
1
9
GB/IE/NI