Notch Cuts; Maintenance And Care - Batavia Floormaster Bedienungsanleitung

For cutting hold the laminate firmly with one hand and
pull the handle down with the other hand. Continue
cranking the handle until the cut is complete. There is no
need to push the plank; the patented dual blade system
automatically will feed the plank while cutting.
Note: If the plank begins to move off the cutting line, stop.
Reverse (fig. 2a) the directional switch (F) and push the
handle to back out the plank. Once you have re-aligned the
plank flip the directional switch to resume cutting in a
forward direction.
The cut side of the plank should be placed along the wall.
The cut side of the plank (unfinished) will then be covered
by baseboard or finish moulding.

Notch Cuts

1. Mark the notch you want to cut out. Notches are used around door ways or
other obstructions in the layout of the floor.
2. Cut along the mark and once the desired notch length has been reached, flip
the directional lever (F) and completely back out the laminate plank (fig. 3).
3. Repeat the process for the other side of the notch (fig. 3a).
3

Maintenance and Care

Keep the laminate cutter clean by using a dry clean cloth.
Store the unit in a dry place when not in use.
Periodically check all assembled parts and ensure firm setting.
Remove dust and debris from the opening between the saw blades and the
base.
Operation Operation
3a
8
2
2a