Mellerware Warmy Bedienungsanleitung Seite 18

- The control panel will light up.
- Press the on/off button (1) on the
control panel or the button (14) on the
remote control.
- The appliance will be in operation and
the temperature symbol will flash
showing the default temperature
selected.
- Once the numbers stop flashing, the
room temperature is displayed.
- After a while, the temperature and
on/off indicator will disappear and the
current mode symbol (9, 10, 11 or 12) will
be displayed.
NOTE: Temperature readings on the
gauge may differ slightly from readings
on other temperature measuring
devices.
- To turn off the device, press the on/off
button (1) on the control panel or the
on/off button (14) on the remote control.
- The convector will go into standby
mode and the digital symbols will show
the room temperature.
- Turn off the convector with the switch
(E).
ADJUST TEMPERATURE
- The temperature can be adjusted from
5ºC to 45ºC.
- The default temperature is 25ºC.
- To set the heating temperature of the
appliance, once the appliance has been
turned on, press one of the buttons (3) (4)
on the control panel or one of the
buttons (17) (18) on the remote control.
- The selected temperature will flash and
with each press of the +/- buttons, the
temperature will increase or decrease by
1ºC and will be saved after 3 seconds if
not pressed again.
- After setting the temperature, the
digital symbols will show the room
temperature.
- If the room temperature is 2ºC higher
than the set temperature, the heating will
turn off. If the room temperature is 2ºC
lower than the set temperature, the
heating will turn on.
ADJUST POWER LEVEL
- Press the mode button (2) on the
control panel or the mode button (16) on
the remote control. This button allows
you to select the following modes;
minimum power (1000W), maximum
power (2000W), automatic mode and
antifreeze mode.
- Each mode will be displayed with its
corresponding icon on the control panel.
TIMER
- While the device is on, press the button
(5) on the control panel or the button (15)
on the remote control to enter the timer
configuration mode. The digital symbols
(9) will be flashing.
- Press one of the +/- buttons on the
control panel or remote control to
increase or decrease the timer by 1 hour.
It is saved after 3 seconds without
pressing any button. The timer indicator
(13) will light.
- The timer can be set from 0 to 24 hours.
- Once the time setting is finished, the
timer indicator (13) will be constantly
shining until the set time runs out.
- With the timer running, you can also
select the temperature and operating
mode.
- To turn off the timer, set the time to 0 or
turn off the device with the on/off switch.
- To check the time, press the button (5)
on the control panel or the button (15) on
the remote control. If no action is taken
after this, the device will continue its
course.