Factory Reset - Carry-On Digital Wind Instrument 2 Pro Bedienungsanleitung

Battery
This product has a built-in rechargeable lithium battery which can support
up to 3 hours of use from a full charge under normal conditions.
To charge please use a suitable USB charger connected to the micro-USB
port. The power LCD will flash slowly to show that your device is charging.
The power LCD will stop flashing once the battery is fully charged. When
the battery power is low, the power LCD will flash to indicate low power.
Continual use of the product while the battery power is low may impair its
performance and can decrease the life span of a suitable power supply
immediately.
To save power, the unit will automatically shut down after 15 minutes
of inactivity.
MIDI over Bluetooth
Your Carry-on Digital Wind Instrument 2 Pro has MIDI over Bluetooth.
To connect your mobile device to your digital wind instrument, please
do not try to connect through your standard Bluetooth settings; instead,
connect via your chosen music app to pair with your device.
Make sure your instrument's MIDI over Bluetooth is switched on, please
refer to No. 13 in the 'Settings Menu' in this manual.
Go to the Settings menu in your chosen music app to pair with your
smartphone. Using GarageBand as an example, go to:
Settings – Advanced – Bluetooth MIDI Devices –
Find 'Carry-on DWI 2 Pro'

Factory Reset

To factory reset your Carry-on Digital Wind Instrument 2 Pro, make sure
your instrument is turned off before following the instructions.
When the power is off, press the Voice button and then hold down the
power button to turn on. Press to reset the factory setting or press
to cancel the factory reset.
14 15