Peraqua OCEAN VAC 2 FUN Bedienungsanleitung Seite 4

AUTOMATIC POOL
Operating instruction:
W e congratulate you to buy this automatic pool cleaner!
Please check the delivery volume:
1, Safety instructions:
F o rth e bes t cleani ng s result
Manually clean pool before installing
cleaner.
F o roptimolsucti on....
Before you install the cleaner, make sure
you have cleaned the filter(including
backwashing) and emptied all baskets.
The ideal hose lengths is the distance
from the suction point to
the farthest corner + 2 lengths of hose.
T o woi d ge dama tothe pump -
Always make sure that your hose is full
of water before starting pump.
D o no t allo w swimm ers inthe pool while t he
clean er isinoperati on!
ng! Warni Sucti on is s! dangerou
CLEANER
2 Installation
Before operation
+) Clean the filter (incl. backwashincj
empty all baskets
+) The cleaner is fully assembled,
it onto the rim of your pool.
+) Connect
hose, put the grey end on your cleaner
head. (Fig.
+) Mount the float on your hose Fig. 4
+) Submerge
opposite the suction port
(ski mmer).
+)Vertically submerge the hose into the
water so that the air can escape and the
hose will fill up with water.
+) Connect
port (Fig. 5)
-OTurn on pump.
+) If necessarry
mers and the main drain (ideally the
right wheel should make approx. 8-12
turns per min. - Fig. 6)
instruction:
:
/
place
all sections of the vacuum
- 3).
co.70cm
the cleaner into the water
the hose with your suction
close the other skim-
IpcFloat
IpcHose cone
10 Hose
After cleaning :
+) Do not leave the cleaner lying in the
sun when not in use.
+) Take the hose sections apart and
store them straight! Fig, 7