Help In The Case Of Faulty Teach-In Process; Radio Receiver - Thomas Centraclean Rp 400 Gebrauchsanleitung

- The yellow LED on the radio receiver
unit will go out.
- Now the teach-in process has been
completed.
- Disconnect the repeater from the exten-
sion cable and connect up to the plug-
box selected for this purpose and place
the repeater at a point affording opti-
mal radio reception as described under
Point 1.
- The central vacuum cleaner can now be
put into operation through the remote
radio control system.
3. Help in the case of faulty
teach-in process
We would recommend that all function
commands on the repeater and radio
receiver unit be deleted and the teach-in
process be started again should the radio
system not function as required.
Note: All the already taught-in compo-
nents (senders or further receivers) will
be deleted when one sender or recei-
ver is deleted!
3.1 Integrated radio receiver/
radio receiver power control
3.1.1 To disconnect sender and repeater
from integrated electronic radio system
Central vacuum unit with integrated electronic
radio system must be ready for operation, see
installation instruction for central vacuum unit.
The following steps are to be taken:
- Set the integrated electronic system to
LEARN status. To do this hold the sender
close to the hood of the system as
shown in the illustration.
- Press sender key into
hold down for 5 seconds. Do not
remove sender! –
shown on the LCD display for 2 seconds.
This LEARN display will be followed by
position and
N
[LERN] will be
N
[CLR] for 3 seconds.
appear for 2 seconds as return signal
from the system.
N N
Now FFB and OPEN will appear alter-
nately in the display.
At this point new senders or repeaters can
be taught-in.
3.1.2 To delete sender from repeater
- Hold the sender close to the repeater as
shown below under 2.1.
- Press and hold down for approx. 5
seconds. The yellow LED will light up on
the repeater. Do not remove sender
from the repeater.
- All previous senders will be deleted as
soon as the yellow LED goes out.

3.2 Radio receiver

3.2.1 To delete repeater from the radio
receiver unit
- Insert the extension cable plug into a plug-
box close to the installed radio receiver unit.
- Hold radio receiver housing close up to
the repeater as shown under Point 2.2.2,
with no space between repeater and
radio receiver unit and connect up with
the extension cable.
- The yellow LED on the radio receiver
unit will light up.
- Disconnect the repeater from the radio
receiver unit.
- The yellow LED will go out after 30 seconds.
This is signalled by a fast blinking LED.
- The deleting process has now been
completed and the repeater can be dis-
connected from the extension cable.
3.2.2 To delete sender from repeater
Proceed as described under Point 3.1.2.
N
[OK] will then