Ibiza MUSHROOM Bedienungsanleitung Seite 2

Please read this manual thoroughly and adhere to the instructions in order to avoid any danger or damage
due to misuse.
Thank you for purchasing this high quality, well-performing light effect IBIZA Light that will give you entire
satisfaction.
Installation
1. Unpack the unit with caution and check if it has not been damaged during transport.
2. Open the lens cover and insert a lamp into the fitting. Please make sure that the unit is unplugged
from the mains! Do not touch the bulb with bare fingers.
3. Choose a suitable well ventilated place. Do not cover the fan and the ventilation slots.
4. Install the unit far from inflammable materials as it becomes very hot during operation.
5. DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
Caution
1. Keep the unit always dry.
2. At the first use, smoke and smell might come out of the unit. This is normal and comes from the varnish
near the bulb. It will stop after a short while.
3. Please replace the fuse always by an identical one. Only use original spares.
4. To ensure sufficient cooling, the fan and the ventilation slots should be cleaned regularly.
5. Regular breaks during the operation of the unit are important to ensure a long life time.
6. This light effect is not built for permanent use.
7. Do not connect this light effect to a dimmer.
8. Shields, lenses or ultraviolet screens shall be changed if they have become visibly damaged to
such an extent that their effectiveness is impaired, for example by cracks or deep scratches.
The lamp shall be changed if it has become damaged or thermally deformed.
WARNING: Use only lamps complying with sheet 357-IEC-3155
Warnings
1. Prior to maintenance on the unit such as replacement of the bulb, make sure that the unit is unplugged
from the mains. The housing contains no user replaceable parts. The housing should be opened by a
qualified technician only.
2. Do not touch any cables or other parts during operation. Voltage carrying parts can cause electrical
shock.
3. Do not touch the housing with bare hands during operation.
4. The bulb becomes very hot during operation. Risk of burnings! Let the lamp cool down before you
replace it.
5. Do not use the unit in presence of people with health problems such as epilepsy.
6. It is strongly recommended not to transport, handle or move the unit when the lamps are still hot. They
might burn out because of the high temperature of the filament.
MOUNTING
Orientation
This fixture may be mounted in a 90°degree angle only, provided there is adequate room for ventilation
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable "C" or "O" type
clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired
position, retighten both knobs.
When selecting installation location, take into consideration lamp replacement access and routine
maintenance.
Safety cables must always be used.
Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes
or restricted ventilation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
© Copyright Lotronic 2011
GB - Instructions for Use
2
Page