Robitronic Shadow Bauanleitung Seite 5

MECHANICAL SPEED
e CONTINUOUSLY RUNNING
CAUSE RESISTOR
R/C modles featuring
a resistor to bleed off excess current heating up resistor
when running at low speeds. Continuously running at low
or mid speeds may result in damaged to the resistor, or
even melting resistor board or cables.
*Resistors become extremely hot during or after use.
Never touch until it cools down as may cause burns.
*Running in a narrowspaceor indoorscancauseresistor
to overheat due to running at low speeds. Always operate
in a wide area only.
"M PROPER MECHANICAL
CONTROLLER ADJUSTMENT
RESISTOR HEAT
Before operating
and adjust mechanical
to stop, low speed,
speed positions,
A speed controller that cannot
speed position can
damaging the resistor.
Battery
'LOW BATTERY POWER
LOSS OF CONTROL.
Loss of control can occur
in either the transmitter
running battery may
control car if your
supplied by the running
immediately if the vehicle starts to slow down.
'RECHARGE CORRECTLY.
Carefully follow the instruction
with battery and charger,
battery when necessary.
may damage battery
could build up heat
becomes extremely
please ask your local hobby shop for check/repair.
CONTROLLER
AT LOW SPEED
HEAT BUILD UP.
mechanical speed controller
RESULTS
BUILD UP.
RIC model, always
speed, controller
medium speed
using your transmitter
switch to the top
result in heat build
WILL RESULT
due to a weak
or the receiver. A weak
also result in an out of
car's receiver power
battery. Stop operation
manual supplied
and only recharge
Continual recharging
and, in the worst
leading to fire. If battery
hot during recharging,
'PLEASE
RESPONSIBLY.
WILL
INTO
•WHEN
use
DISCONNECT
'DO NOT
BATTERY
If the running battery short-circuits,
electricity
Never disassemble
MODIFYING
Modifying
overcharging
SPEED
'DO NOT
IN
BATTERY
After use, battery retains heat. Wait until it cools
check
down before recharging.
switches
and top
'ALWAYS
RECHARGING
up,
IN
battery
is
IMMEDIATELY
MODEL
CIRCUIT
case,
4
DISPOSE OF
NEVER
FIRE.
NOT USING RIC MODEL,
AND REMOVE
DISASSEMBLE BATTERY
CABLES.
can be discharged, leading to fire or burns.
battery or cut battery cables.
CHARGER •S DANGEROUS.
the charge may cause
leading to a serious accident.
RECHARGE BATTERY
•S STILL WARM.
UNPLUG CHARGER
IS FINISHED.
UNPLUG
DISCONNECT
STOP RUNNING
GETS WET, AS MAY
IN IT'S ELECTRICAL
BATTERIES
PUT BATTERIES
ALWAYS
BATTERY.
OR CUT
approx.300W of
short-circuit or
WHILE
WHEN
IF YOUR RIC
CAUSE SHORT
COMPONENTS