Joyetech eGrip VT Gebrauchsanweisung

Notice for Use:
Thank you for choosing Joyetech products! Please read this manual carefully to ensure proper use For any
additional information or questions regarding this product or its use, please consult your local Joyetech
retailer, or visit Our website at www_joyetech com
Product Introduction:
eGrip VT, applies with the Variable Temperature
(Nickel-200)/ VW mode with an OLED screen. It also boasts a 360-degree
wattage or temperature The compact size with multiple colors catering to your preference
comfortable to hold
Specification
Size: 46 4mm*20 4mm*99 5mm
(including mouthpiece)
Battery Capacity: 1500mAh
Output Mode:
VT-Ni/VT-Ti/VW Mode
E-juice Capacity: 3 6m'
Resistance Range:
0 2-1 Oohm for VT mode
0 4-3 50hm for VW mode
Mouthpiece
eGriWVT
4. Adjust the wattage/temperature@):
Under VW mode, rotate the ring around the button clockwise or counterclockwise
to increase or decrease the wattage (5W-30W); under VT mode, rotate the ring
around the button clockwise or counterclockwise
temperature (100-315 c 1200-600"F ).
Rotate the ring faster clockwise or counterc ockwise for continuous three grades,
the device automatically increase or decrease O.IW/5 C (10T ) numerically
5. Regulation of air-inlet2):
Spin the adjustment screw on the side of the button. Counterclockwise
will loosen the screw The looser the screw is, the larger the air inlet is
6. Atomizer head replacement(S):
Unscrew the cap on the bottom with the tiny tool in the box (Or just a coin),
you' II see the atomizer head located right on the base Then replace the head
with a new one.
7. e-Juice Filling@):
Push up the lid on the side of the body, then slowly refill the liquid into the hole
(Note: Don' t forget to lock the cap after finishing it )
eGrip*VT
3
After fitting a new coil, press the fire button while the atomizer base is removed to initiate a reset After you
reinstal the atomizer base with a new head, the screen will appear "new coil up, same down"
regulation ring clockwise to confirm that a new coil has been fitted
Should you see this message for any other reason, especially when reinstalling the same coil that is still warm
after use. If so, rotate the regulation ring counterclockwise so that the 'basic resistance" won' t be reset.
4. Device Too Hot Alert:
When the device' s inner temperature passes over 70 C, the output will shut off automatically
screen will appear 'Device TOOHot' for 5 seconds. After then, it switches back to normal
5. Temperature Protection:
Under VT mode, if the coil' s actual temperature reaches to the set temperature, the device wil
Protection"
6. Over IOS Protection:
If you keep pressing the fire button for more than 10 seconds, the screen will appear "Over IOS"
7.Atomizer Short-circuit Protection:
When atomizer short-circuit occurs, the screen will appear "Atomizer Short"
5 eGrWVT
1_This warranty provides repair free of charge for defective Joyetech brand merchandise
90 days from date of purchase by the end user.
2. This warranty may be void as a result of any of the fol owing conditions:
• Customer does not provide warranty card and original receipt of purchase.
Merchandise failure or damage is caused due to improper use or unauthorized repair.
* Merchandise failure or damage as a result of excessive force such as dropping
• Merchandise failure or damage as a result of usage outside of recommended
precautions in usage manual).
* Merchandise failure or damage caused by improper use of water or other liquid (see usage manual for
operating instructions)
Merchandise failure or damage due to usage with non-Joyetech components (charger, battery, and power cable).
3 This warranty does not cover personal items or consumable
limited to: mouthpiece, cartridge, atomizer head, anyard, and leather sheath.
4. This warranty does not cover any non-Joyetech
Joyetech brand products during the warranty period Of 90 days after date Of purchase as indicated on proof
of purchase
eGripWVT English
7
Control system, supporting VT-Ti (Titanium)/
regulation ring to adjust output
makes it always
CL-Ni Head CL-Ti
CL 1 OQ Head
eGrip VT Body
to increase or decrease the
rotation
Rotate the
show "Temp
Warranty period is
operating conditions
goods and attachments, including
brand products. This warranty is only valid for eligible
How to Use
1 .Power on/off:
Press the fire button 5 times in quick succession to turn the device on
n the same way, the device wil be powered Off after 5 presses
2. Vaping:
VT-Ni
Hold the fire button and inhale through the mouthpiece
3. Shift between VT-NVVT-TVVW
Press the fire button for three times to shift between VT-Ni/ VT-Ti/VW Modes when the battery is on
(1) under VW mode, it presents: battery life, ohm, voltage and wattage
Head
(2) under VT mode, it presents: battery life, Ohm, wattage, temperature and mode (Ni/Ti)
eGrip
CL Base
8. Vent Pipe Cleaning:
The vent pipe of eGrip VT is detachable. Take off the mouthpiece then use the tiny tool in the box (or just a
coin) to unscrew the vent pipe from the top so as to clean it individually
9.Charging: Plug into the charging port at the bottom. It usual y takes 2.5 hours to fully charge the battery
via IA wall adapter
Indications:
1. Screen:
(2)
The OLED screen presents watts, ohms, temperature, battery life and timing whi e vaping
(3)
2. NO Atomizer Alert: When the coil is not insta led properly, the screen wil appear "NO Atomizer"
3. New Coil Alarm:
When installing a new coil whose resistance is larger than the previous one to some degree, resetting the
"basic resistance" (resistance at room temperature)
8.Atomizer Low Alert:
When the atomizer resistance is lower than
"Atomizer Low" will appear on the screen
9.Low-voltage Protection:
When the battery voltage is lower than 3 3V, the screen will appear "Battery Low" and "Lock"
battery is locked Recharging to un Ock the battery
and the Note:
1 Under VT mode, please install the temperature control coils at room temperature ;
2 Only use temperature control coils under VT mode Damages will be caused when temperature
coils are accidentally used under VW mode
3.VT mode only supports a maximum Of 1 Oohm It will automatically
larger than 1 Oohm or using a normal coil under VT mode
Warranty Terms
Please check your Joyetech Warranty Card We are not responsible for any damage caused by user error
Our warranty is not valid for products purchased from third party vendors
Joyetech agrees to provide repair under warranty pursuant
Joyetech reserves the right of final decision
Joyetech may interpret and revise the content of this warranty terms.
(see
but not
Release the Fire button and exhale
Modes:
shall be required
0 40hm under VW mode or lower than 0 20hm
switch to VW mode when the coil is
to the following terms and conditions:
in all warranty cases.
ErglishIeGriBVVT
2
4
under VT mode,
Thus the
control
ErglishIeGrip'VVT
6
8