Philips MasterConnect GU10 Installationshinweise

PHILIPS
LED
MasterConnect
GUIO
Quicl<
Installation Guide
This Quick Installation Guide contains important information and notes regarding
the installation of Philips MasterConnect
installation.
Product is dimmable by wireless control. DO NOT use with a wall dimmer.
Operate with direct mains only.
Product must be used in dry environment and in luminaires that are approved for the application.
Operating ambient temperature from -200C to +450C.
Must be used with compatible control devices.
Product should be use within specified radio-frequency (RF) communication range.
This range can vary depending on actual application environment.
interact
LED
ready.
PHILIPS
LED GU I Os.Please read carefully before
Follow the instructions below to install the product(s). Different systems may
require physical installation of devices at a different stage during system setup.
You're required to read the system guide to understand the complete and
proper sequence.
After power on, lamps will automatically search for available Zigbee network and
connect to a Zigbee gateway (if any). Lamps can also be commissioned by using a
designated Bluetooth mobile application. Please refer to our website for instructions
on app download.
When needed, performing factory reset will restore a lamp to its default state. Lamp
will be removed from its current network (if any) and all settings will be deleted.
l) The lamps can be reset from the system app when credentials are properly
kept and lamps are accessible. In this case please follow the in-app instructions.
2) If credentials are lost, lamps will need to enter safe-mode in order to be reset.
Turn the lamps off for 5 seconds, then on for 5 seconds. Repeat 5 times to
activate safe mode. Visit our website to download the tool for factory reset.
Hereby, Signify declares that the radio equipment is in compliance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is available at the following internet address:
www.philips.com/lighting
Wireless RF mode Frequency Range:Bluetooth Low Energy: 2402-2480 MHz, Zigbee: 2405-2480 MHz
Output power (Conducted): Bluetooth Low Energy: 4dBm, Zigbee: 4dBm
The Bluetooth@ word andlogosare registeredtrademarksownedby BluetoothSIG,INC.
Pleaseinform yourself about the local waste disposal,separation and collection system for electrical and electronic products
and packaging.Pleaseact according to your local rules and do not dispose your old product and packagingwith your normal
household waste.The correct disposal of the packaging,your product and/or batteries will help prevent potential negative
consequencesfor the environment and human health. Batteries should be disposed separately from the municipal waste stream via
designated collection facilities.VVhen disposing a product that contains non-user replaceable batteries, the non-user replaceable batteries
shall be removed by a professional.
All rights reserved. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner.
The information presented in this document does not form part of any quotation or contract, is believed to be accurate and
reliable and may be changed without notice. No liability will be accepted by the publisher for any consequenceof its use.
PHILIPS
publication thereof does not convey nor imply any license under patent or other industrial or intellectual property rights.
Signify
Eindhoven, the Netherlands
000800-74454775
wvm.philips.com/lighting
Philipsand the PhilipsShieldEmblemare registeredtrademarks of KoninklijkePhilipsN.V. andare used under license
@2022 Signify Holding
Oignify
3241 656 35652