RedLINK Argus 2E Bedienungsanleitung Seite 8

Important Notes on Rechargeable
Reolink Argus 2E is not designed for 24/7 full capacity running or around-the-clock
streaming. It's designed to record motion
when you need it. Learn useful tips on how to extend the battery life in this post:
https://support.reolink.com/hc/en-us/articles/360006991893
I. Charge the rechargeable battery with a standard and high-quality
or Reolink solar panel. Do not charge the battery with solar panels from ang other brands.
2. Charge the battery when temperatures
when temperatures are between -200C and 600C.
3. Keep the USB charging port dry, clean and free of ang debris and cover the USB charging
with the rubber plug when the battery is fully charged.
4. Do not charge, use or store the battery near any ignition sources, such as fire or heaters.
5. Do not disassemble. cut, puncture, short-circuit the battery, or dispose of the battery in water,
fire, microwave ovens and pressure vessels.
6. Do not use the battery if it gives off an odor, generates heat, becomes discolored or deformed,
or appears abnormal in any wags. If the battery is being used or charged, remove the battery
from the device or the charger immediately, and stop using it.
7. Always follow the local waste and recycle
13 English
Battery Usage
live
events and remotely view live streaming only
DC 5V/9V battery charger
are between OOCand 450C and always use the battery
laws when gou get rid of the used battery.
Troubleshooting
Camera Is Not Powering
If your camera is not turning on, please
apply the following solutions:
• Make sure the power switch is turned on.
• Charge the battery with a DC 5V/2A power
adapter. When the green light is on,
the battery is fully charged.
If these won't work, p ease contact Reolink
port
Support https://support.reolink.com/.
Failed to Scan QR
Code on the Phone
If you cannot scan QR code on gour
phone, please tru the following
• Remove the protective film from the
camera lens.
• Wipe the camera lens with a dry
paper/towel/tissue.
• Vary the distance between your cameraand
the mobile phone so that the camera
can focus better.
• Try to scan the QR code under sufficient
on
lighting.
If these won't work. please contact Reolink
Support https://support.reolink.com/.
Failed to Connect
Initial Setup Process
If the camera fails to connect to WiFi, please
tru the following solutions:
• Please make sure the
because the camera does not support 5GHz.
• Ensure that you have entered the correct
WiFi password.
• Put the camera closer to gour router to
solutions: ensure a strong WiFi signal.
• Change the encryption method of the WiFi
network to WPA2-PSK/WPA-PSK
(safer encryption) on your router
• Change gour WiFi SSID or password and
to WiFi During
WiFi band is 2.4GHz
interface.
| 14
English