Name Of Parts; Switch Setting - Ikegami Rsu-871 Bedienungsanleitung

4. Name of parts 5. Switch Setting
5-1. Cable Compensation Switch
Set the switch according to the cable length between the RSU-871 and a camera.
Switch position
Cable L
3C-2V (RG-59/U) Less than 125m (410ft) 100m (325ft) - 250m (820ft)
5C-2V (RG-6/U) Less than 250m (820ft) 200m (650ft) - 500m (1640ft)
5-2. Internal DIP Switch
The internal DIP switch (SW3) is used to select the camera type and an RS-232C communication
baud rate.
ore ov [we — —
When the power is turned On, a cam-
- C ICD-87 2
Se) EES GE 212 era type is identified automatically.
ti BE :
SW3-2 | Baud rate 9600 bps 4800 bps a communication error happens of
ten, chenge to 4800 bps.
Notes: 1) Before you will change the DIP switch position, be sure to turn OFF the power.
2) The camera type will be selected automatically regardless of the SW3-1 position.
Only in case of communication error, the setting of SW3-1 will be effective.
DC12V IN POWER
+
ep LII
©) ngo
RS-232C CABLE
(D POWER switch
Used to turn on and off the power. yen
@ DC12V in terminal
Used to connect an external (DC12V) power supply.
@ VIDEO IN connector
Connect to the video output of a camera.
@ VIDEO OUT connector
Connect to the video input of a monitor or VCR.
(5) CABLE COMP-switch
This is for a cable compensation amplifier.
(8) RS-232C connector
Used for an RS-232C interface.
@ Indicator
It indicates Power-On or communication error.
Lock screw
Remove the 4 screws to open the case and set the DIP switches.
(8) Internal DIP switch (Inside of case)
Used to select camera type and baud rate.
E-2 E-3