Wall Mounting - Audio Pro LV-Sub-Flat Bedienungsanleitung

pairing witH tXd200/lv-HuB transmitters
wallmOunting
prepare the included wallmounts first and attach to lv-suB with enclosed screws suitable. secure
suitable screws in your wall according to drill guide. use screw suitable for your wall material
(screws not included) and the weigth of lv-suB flat. Hang the subwoofer on to the screws secured
in the wall. keep lower rubber feet on, as they are used as distances to your wall.
6
The feature to pair LV-SUB flat only works with the TXD200 and LV-HUB
transmitter, and in combination with newer Living speakers with pairing
functionality.
lv-suB flat also works with standard tX100 transmitter.
By pairing, you lock your audio pro network from other peoples audio
pro wireless networks. in unpaired mode, the tXd200 and lv33 will work
with all audio pro wireless products.
pair yOur lv-suB flat witH tXd200/lv-HuB transmitter
1. press pairing button on transmitter for 2 seconds. led starts to flash
green.
2. press and hold ZOne/pair button on lv-suB flat for 3 seconds.
(Button is located on rear amplifier panel). led starts to flash green, and
display shows: Pr -
3. when leds on both transmitter and subwoofer goes to steady green,
the subwoofer is paired to your system.
note:
1. pairing will not work with older living speakers.
2. to unpair system (all speakers in same volume zone will be unpaired):
- disconnect tXd200/lv-HuB from power.
- while pressing the pairing button, reconnect tXd200 to power, and hold pairing button for
6 seconds. the units will now be unpaired.
Drill guide:
346mm