Audio Pro LV-Sub-Flat Bedienungsanleitung Seite 5

JOin lv-suB flat tO eXisting audiO prO netwOrk
to use the lv-suB flat wirelessly, you must have an audio pro transmiter (tX100, tXd200 or
lv-HuB). lv-suB flat automatically connects to your existing network. simply set the same House
code and Zone that your existing lv loudspeakers use and connect the lv-suB flat to a power
socket.
cOnnecting tHe lv-suB lat tO an eXisting netwOrk fOr tHe first time:
to synchronise volume levels so the lv-suB plays at the same level as other loudspeakers in the
network:
1. ensure that all the loudspeakers in the zone (a, B or c), including the lv-suB flat, are switched
on and set to the same Zone and House code (all lv loudspeakers are set to zone a as default).
2. set the level on the rear of the lv-suB to the middle position (0).
3. raise or lower the volume using the remote control's Zone volume: a, B or c.
(point the remote control at the receiving loudspeaker, e.g. lv-1, lv-2 or lv-3 loudspeaker)
4. the volume levels for all units in the zone should will now be synchronised.
if you do not synchronise the levels, the lv-suB may emit too little or too much bass.
(you can manually raise or lower the bass volume if you desire more or less bass.
the controls for this can be found on the rear of the lv-suB.)
note:
- the lv-suB flat volume is controlled in the network using the same remote control as for audio
pro's wireless lv loudspeakers. set to same House code and Zone as the speakers you want lv-suB
flat to play with
- manual default settings, such as subwoofer volume and crossover frequency, can be found on the
rear of the lv-suB flat.
5