Proxxon HKP 220 Bedienungsanleitung Seite 7

First carefu ly clean and drythe glue pisto
Remove any films of grease with solvent
Fig 4: On flexible materials (carpet, card
board. textiles etc.), the glue can also be ap
plied in waw lines
Changing the nozzle
Fig 5:screw on the nozzle required (normal.
caulking, flat) The machine is delivered With
the normal nozzle fitted
Please note before chang'ng the nozzle. the
HKP 220 must be heated far at least 5 min—
utes Simply plug it in The metal nozzles
have a thread and a ld-mm hexagon They
Canbe Changedusing a I O-mm C spanner
ora pair of pliers Do mottouch
the pistol while changing - risk of burns!
Glued joints can be released by heating (hot
air gun). Drops Ofglue can be easily re-
moved once they have cooled When gluing
heat sensitive materials, apply the glue to
the less sensitive side.
What do pu do the nozzle is blocked?
Ifthe glue is fed with too much force, the
glue stick can adhere in the nozzleand
block it. If this happens, heat the HKP 220
far at least 10 minutes and carefully pull the
glue stick out backwards Ifthe glue stick IS
too short to grasp from the rear, heat the
end of a new stick with the nozzle and insert
it in the back ot the pistol so that it is glued
to the Old stick. They can then be pulled out
together
EU declaration Of conformity
Manufacturer'S
PROXXON
6-10. Härebierg
L-6868
Article No: 28192
We declare, on our own responsibility, that
this product conforms to the following stan-
dards and specifications
EU Low Voltage Directive
EU EMC Directive
the nozzle in
Date: 25 06 21m
DipI -Ing Jörg Wagner
PROXXON S A
Machine Safety Department
and address:
S A
VVecker
name:
220
2006/95,'EEC
2004/ 108/ EEC