Proxxon HKP 220 Bedienungsanleitung Seite 6

Translation
Operating
Hot Glue
Always keep these instructions ready to
hand this machine in full knowledge Of
and in accordance
PROMON does not accept iability for safe
and sureoperation of the machine in the
event of.
• manipulations that do not correspond to
normal use,
• use for purposes other than those named
in the
• failureto
You have no guarantee
event of:
• •mproper use,
• improper or inadequate maintenance
For pur own safety. do not fail to observe
the safety instructions
Only use original PROXXONspare parts
We reserve the right to make further deve
oprnentS in line With technical progress We
wish you every success with your machine
Description Of the machine
The HKP 220 Will quickly and reliably glue
metals, mood, plastic Oncludingacrylic
resin). glass. ceramics. earthenware. card
board, leather, foamed
tiles
Depending on the work piece
applied quantity, the adhesive requires up to
30 seconds to cure. The great advantage as
opposed to superglue: It is possible to Cor-
rect the seat within the curing time The 7
mm glue sticks are easily fed by feel using
the mechanical
short - about 5 minutes
perature contro (PTC) maintains the heating
element at approx 230 oc
Of the Original
Instructions
Pistol HKP 220
with the instructions
the safety instructions.
materials and
The Warmup time is
An electronic
Included in delivery:
1 HKP 220
I Normal nozzle
I caulking nozzle
I flat nozzle
4 spareglue sticks
Technical
220-240 volt-,
40 watt
Melting temperature. 230 'C approx.
control ed)
Housing in glass fibre reinforced nylon
For 7-mm dia. glue sticks
How to use the
the
• during operation, glue and nozzleare
heated to 230 00, do not touch!
risk ot burns!
• only use sticks, not pastes or liquid glue,
make
come into contact Withhot tip or hot glue!
• always unplug after use.
• keep children away from the work area
The fol owing shou d be read in conjunction
with the illustration
operating
Fig 1:when required, insert anew glue stick
in the back of the pisto
and
fig 2: pull out the
the machine down using this as a support.
unplug and waitfor about 5 minutes. This can
also be used as a convenient way of putting
the machine down during pauses in work.
Fig 3: operate the feed ever (I) by fee and
tem
apply the glue to one side ot the work The
glue should not be applied to the whole sur
face but in spots The larger the surface, the
arger the spots
data:
50/60 Hz
machine
sure that the mains
on the left of the fold-out
the HKP 220
as shown and set
lead does not