Hdd Initializing And Formatting - Fantec QB-X2US3R Benutzerhandbuch

7. There are 4 mode options for Qb-X2US3R, JbOD, bIG,
RAID 0 and RAID 1.
The enclosure is NOT default to any of the above. So If you just put
hard drives in without setting a mode to use, the enclosure will just
turn off after a few seconds of turning it ON. The confirmation button
is hidden in the back, so please find it first before you start.
The setup procedures are as follows,
Make sure the enclosure is connected to a computer that is ON.
a
Power on the enclosure and press and hold MODE button on the
b
front until mode option LED flashes. Press it again to select the
RAID mode you want then press the confirmation button on the
back panel until the device shuts down.
Power on the device again and the RAID mode set-up is
c
completed. Now you just need to partition and format the drives.
changing RAID mode may cause data lost, backup
your data before making changes.
FANTEC QB-X2US3R 2-BAY 3.5" RAID
8. FAN mode setup, users need to press the „FAN" button to change
mode.
Defaut Setting is at "AUTO" mode.
10) h I
DD nItIalIzIng anD formattIng
MS Windows (32/64 bit)
If the hDD is uninitialized, you may have to initialize it by doing steps
as followed: At first click "Start" at your Pc and key in "diskmgmt.msc".
After that please press "OK" key.
1. Start disk initialization.
FANTEC QB-X2US3R 2-BAY 3.5" RAID
34 35