Battery Replacement; Precautions - Philips Awp3705 Bedienungsanleitung

Filter cartridge model code
AWP 305
AWP 315
Once the right number is selected, release the reset button. Now the reset is done.
E. Let the water run for 5 seconds under the un�ltered mode, and 3 minutes under the
�ltered mode.
E1-1

Battery replacement

When the battery power is lower than 5%, the brightness of the display will decrease.
When the display stops showing numbers even there is water �owing through the on-tap,
the battery needs to be replaced.
(1) Pull out the battery cover and install a new battery into the battery cover. Please pay
attention to the direction of the positive and negative poles.
(2) Push the battery cover back to the on-tap and make sure it is in place.
(3) After replacing the battery, the display will continue to show the lifetime of the �ter
cartridge.
D1-1

3. Precautions

Warning
- This device is intended for domestic use only.
Filter capacity
1,000 l
1,200 l
D1-2
8
D1-3