Know Your Product - Ryobi R18Gs18 Bedienungsanleitung

flow inside them. Corrosive or conductive fluids, such
as seawater, certain industrial chemicals, and bleach
or bleach-containing products, etc., can cause a short
circuit.
■ Ambient temperature range for battery during use is
between 0 °C and 40 °C .
■ Ambient temperature range for battery storage is
between 0 °C and 20 °C .
TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local and national
provisions and regulations.
Follow all special requirements on packaging and labelling
when transporting batteries by a third party. Ensure that
no batteries can come in contact with other batteries
or conductive materials while in transport by protecting
exposed connectors with insulating, non-conductive caps or
tape. Do not transport batteries that are cracked or leaking.
Check with the forwarding company for further advice.

KNOW YOUR PRODUCT

See page 68.
1. Battery port
2. Air pressure dial
3. Handle, insulated gripping surface
4. Trigger switch
5. LED light button
6. Mode selector
7. Belt clip screw hole
8. Magazine release button
9. No-mar pad
10. LED light
11. Depth of drive adjustment
12. No-mar pad
13. Safety contact tip
14. Belt clip
15. Belt clip screw
16. Operator's manual
17. Battery pack
18. Charger
MAINTENANCE
■ The product should never be connected to a power
supply when assembling parts, making adjustments,
cleaning, performing maintenance, or when the product
is not in use. Disconnecting the product from the power
supply will prevent accidental starting that could cause
serious injury.
■ When servicing, use only original manufacturer's
replacement parts, accessories and attachments. Use
of any other parts may create a hazard or cause product
damage.
■ Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
■ Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which may result in serious personal
injury.
■ For greater safety and reliability, all repairs should be
performed by an authorised service centre.
4
Original Instructions
SYMBOLS
Safety Alert
Direct current
Fastener length
Fastener width
Please read the instructions carefully before
starting the machine.
Wear eye protection
Keep hands away
Flashing LED light indicates low battery or
that troubleshooting is needed. Refer to the
Troubleshooting section.
Depth adjustment
Full sequential actuation
Contact actuation
Do not dispose of waste batteries, waste
electrical and electronic equipment as
unsorted municipal waste. Waste batteries
and waste electrical and electronic
equipment must be collected separately.
Waste batteries, waste accumulators, and
light sources have to be removed from the
equipment. Check with your local authority
or retailer for recycling advice and collection
point. According to local regulations,
retailers may have an obligation to take
back waste batteries and waste electrical
and electronic equipment free of charge.
Your contribution to the reuse and recycling
of waste batteries and waste electrical and
electronic equipment helps to reduce the
demand of raw materials. Waste batteries,
in particular containing lithium, and waste
electrical and electronic equipment contain
valuable and recyclable materials, which
can adversely impact the environment and
the human health if not disposed of in an
environmentally compatible manner. Delete
personal data from waste equipment, if any.