Assembly - Rusta Dac 320El Bedienungsanleitung

EN
5.1 Fitting the guide rail and chain (fig. A – E).
1. Place the chain saw on a stable surface.
2. Install the front guard/chain brake assembly in the forward position (fig. D).
2. Completely loosen the chain tensioning nut (9) (fig. A).
3. Remove the chain cover assembly (10).
4. Make sure the marks (14) on the tension adjustment ring (5) are aligned.
5. Position the chain (6) on the guide rail (7) making sure the chain edges are on top of the guide rail (7) facing forward
(fig. B).
6. Guide the chain (6) around the guide rail (7) and pull it to create a loop on one side at the rear end of the
guide rail (7).
7. Guide the chain (6) around the drive wheel (12). Place the guide rail (7) on the rail locating pins (13).
Warning! Make sure the front guard / chain brake assembly (4) is in the engaged (forward) position before
refitting (fig. C).
8. Position the chain cover assembly (10) on the saw.
9. Turn the chain adjuster knob (9) to attach the chain cover assembly (10), but do not tighten completely.
10 . Turn the chain tension adjustment ring (5) clockwise until the chain (6) is tight. Make sure the chain (6) fits
around the guide rail (7).
11. Check voltage as described below. Do not squeeze too hard.
12. Tighten the chain adjustment lock knob (9).
6