Electrical Safety - Rusta Dac 320El Bedienungsanleitung

EN
a. The power tool plug must match the outlet. Never modify the plug in any way. Do not use plug adapters with
grounded (grounded) power tools. The unmodified plug and compatible sockets will reduce the risk of electric
shock.
b. Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the risk of
electric shock.
c. Do not mishandle the cable. Never use the cord to carry, pull or unplug the power tool. Keep the cable away
from heat, oil, sharp edges or moving parts. Damaged or tangled cables increase the risk of electric shock.
d. When operating a work tool outdoors, use an outdoor extension cord. Using a cable suitable for outdoor use
reduces the risk of electric shock.
e. If operating a power tool in a damp area cannot be avoided, use a power supply with residual current device
(RCD) protection. Using an RCD reduces the risk of electric shock.
This tool features double insulation; therefore, no grounding is required.
Always check that the power supply matches the voltage on the specification sheet.
If the power cord is damaged, it must be replaced by the manufacturer or an authorized RURIS
service point to avoid danger.
Safety recommendations
a. We strongly recommend that first-time users of the tool receive hands-on training in chainsaw operation from
an experienced user and use protective equipment. An initial practice should be done by sawing logs positioned
on a trellis or cutting frame.
b. Before use, always check that the recoil brake is working properly.
c. We recommend that when transporting the chain saw, ensure that the brake is engaged and that the saw is
facing backwards.
d. Perform maintenance on the chain saw when not in use. Do not store the chain saw for short or long periods
of time without first removing the saw chain and guide rail which must be kept immersed in oil. Store all chain
saw components in a dry, safe place out of the reach of children.
e. We recommend emptying the oil tank before storage.
f. Make sure you have a stable position and plan ahead for safe evacuation in case of falling tree or branches.
g. Use chocks to help control the fall and prevent the guide rail and saw chain from getting stuck in the cut.
h. Saw chain care. Keep the saw chain sharp and securely fastened to the guide rail. Make sure the saw chain
and guide rail are clean and free of oil. Keep handles dry, clean and free of oil and grease.
Using an extension cord
Always use an approved extension cord suitable for the power draw of this tool (see technical specifications).
The extension cord must be suitable for outdoor use and must be properly marked. An extension cable with a
cross-section of 2 X 1.5 mm
Extension cords whose length is over 25 m must have a cross-section of at least 2.5 mm
the extension cord for signs of damage, wear and aging. Replace the extension cord if it is damaged or defective.
When using a cable reel, always unwind the cable completely.
Be careful not to get electrocuted!
Prevent body contact with grounded or grounded surfaces (eg metal rails, light poles, etc.). Electrical safety can
be further improved by using a high-sensitivity (30 mA/30 mS) residual current device (RCD) protection.
Warning! The use of an RCD or other interrupting device does not exempt the chain saw operator
from following the safety instructions and safe work practices provided in this manual.
Residual risks
Additional residual risks may occur during use of the tool, risks that may not be included in the attached safety
warnings. These risks can be determined by incorrect use, prolonged use, etc.
Even with the application of appropriate safety regulations and the implementation of safety devices, certain
residual risks cannot be avoided. These include:
-Injuries caused by touching rotating/moving components.
-Injuries caused when changing components, blades or accessories.
4

2.4. ELECTRICAL SAFETY

2
can be used up to 25 m long without affecting the performance of the product.
2
. Before use, inspect