06. Operation
Regardless of the charging state of the battery pack, you are always
able to use the hair trimmer with the wall power supply.
1. In order to use the wall power supply, ensure that the device is
switched off.
2. Connect the wall power supply to the hair trimmer.
3. Insert the wall power supply into an easily accessible socket.
4. Use the on/off switch (3) to switch on the hair trimmer.
5. The power indicator light goes out during mains operation.
Replacing/Adjusting the vario comb attachments
WARNING! Risk of injury from cutting
• Switch off the device before replacing or changing the
comb attachments.
• Push on the comb attachment by carefully inserting
the guide arms of the comb attachment into the lateral recesses of
the device until it locks into place.
• Set the cutting length: Set to the desired position by moving
up / down.
• To remove the comb attachment, first switch off the device and
then grasp the attachment by holding the two guide arms with your
thumb and pointer finger, and pull it out off the lateral recesses.
Cutting hair
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting angle.
• First, start with a comb attachment for a longer cutting length
and then, in the course of the cutting process, use shorter cutting
lengths step by step.
31