AXENT ZERO Bedienungsanleitung Seite 20

CLEANING AND CARE
C LE AN I N G I N STR U CTI O N S C E R AM I C
Under no circumstances should you use harsh or abrasive cleaning substances such as
abrasive cream cleansers, scouring powder or drain cleaner on your ceramic surfaces. Also
avoid using steam cleaners and hard, abrasive sponges. Please bear in mind that hair colouring
products can reduce the effectiveness of AXENT Easy Clean.
If you follow this guidance then you should remain satisfied with the performance of AXENT
Easy Clean for many years. Recommended cleaners for sanitary ceramic surfaces with
AXENT Easy Clean finish. The use of acidic cleaners with a pH value between 1 and 4 is highly
recommended. Cleaners with a pH value in the neutral range (5 to 8) are not always suitable.
We strongly advise against using either weak or strong alkaline cleaners, i.e. substances with
pH values from 9 to 12.
C LE AN I N G TH E R E M OTE CO NTRO L
Wipe the remote control with a soft cloth (cotton, not microfibre).
C LE AN I N G I N STR U CTI O N S S E AT, LI D AN D R E AR COVE R
To continue enjoying your toilet seat and lid for as long as possible, please follow these care tips.
Clean them regularly and promptly to prevent stubborn mineral stains.
Clean surfaces thoroughly with a soft cloth (cotton, not microfibre).
– Use clear, warm water, and a bit of gentle detergent to remove heavier soiling.
– Do not use spray cleaners or microfibre cloths.
– Leave the toilet seat and lid open while the detergent acts on ceramic surfaces.
– Do not use detergents that foam or contain chlorine.
The seat of the AXENT.ZERO contains electronics, therefore do not immerse
or rinse in water!
16 EN