Installation Requirements; Operation Warnings; Transportation Requirements - Bosch PAD 12001 Gebrauchsanweisung

Installation requirements

mín.
20 cm.
20 cm.
Operation
warnings
Transportation
requirements
24
❏ This appliance must be connected to a 220/240
❏ It must be protected with a 10 A slow-action fuse.
❏ Should an extension lead be needed, this lead
❏ There is a cavity at the back of the appliance for
❏ Do not allow water to enter the appliance.
❏ Do not block the air inlets or outlets on your
❏ To ensure correct appliance operation, maintain
mín.
❏ The mains electricity supply connection cable
Fig. 4
❏ When the appliance is switched on and set to
❏ Be careful on removing the tank from the
❏ If the appliance is turned off and then turned
The appliance is fitted with wheels in order to make
it easier to move. Should it be necessary to tilt the
appliance in order to move it, empty the removable
water tank beforehand. See Cleaning and
Maintenance, "Emptying condensed water".
❏ You should not turn the appliance back on again
V 50 Hz mains electricity supply using an
earthed plug.
must be at least 1.5 mm
more than 25 m. long and earthed.
the mains electricity lead.
appliance, especially when used for heating.
minimum distances of 20 cm to adjacent objects.
see fig 4.
must only be replaced by authorised
members of the manufacturer's Official
Technical Service.
work in dehumidification mode, the user may
hear a whistling or bubbling sound. There is
no cause for concern; these noises are not
symptomatic of a fault.
appliance when full of water. Hold the sides
gently but firmly and try to keep the tank in
as upright a position as possible at all times.
back on again, there is a 3-minute interval
before the compressor starts up again. This
interval is necessary in order for the
appliance to work properly.
for a minimum period of one hour.
per terminal thick, no
2