Using The Air Compressor - Ronix Rc-5012 Bedienungsanleitung

WARNING!
Always ensure the switch is in the OFF (O) position and the regulator
pressure gauge reads zero before changing air outlet. Failure to do so
could result in possible serious personal injury.

USING THE AIR COMPRESSOR

1) Ensure power switch is in OFF (O) position and air compressor is unplugged.
2) If not already installed, attach hose to compressor
3) Attach 6.35 mm (1/4 in.) NPT quick- connect air fitting to accessory
or tool you intend to use.
4) Insert the other end of the quick connect air fitting to the quick coupler on
the open end of hose.
5) Connect the power cord to the power supply.
6) Turn the switch ON (1).
7) Pull out and rotate pressure regulator knob to desired line pressure at
the outlet; turning counterclockwise regulator knob to desired line pressure.
Turning the knob clockwise increases air pressure at the outlet; turning
counterclockwise reduces air pressure at the outlet.
8) Following all safety precautions in the air tool manual. You may now
proceed to use your air-powered tool.
WARNING!
Air-powered tools may require more air consumption than this air
compressor is capable of providing. Check the tool manual to avoid
damage to the tool or risk of personal injury.
1) Control the amount of air flow with the pressure regulator knob. Turning
the knob fully counterclockwise will completely stop the flow of air.
NOTE
Always use the minimum amount of pressure necessary for your
application. Using a higher pressure than needed will drain air from
the tank more rapidly and cause the unit to cycle on more frequently.
|
26
Air Compressor 50Liter