Opticum Red AXSBOXplus Kurzanleitung Seite 27

Use the A / V buttons to select between the options UNICABLE
UNICABLE B, UNICABLE
SCD2 C, SCD2 D, SCD2 E, SCD2 F, SCD2 G or SCD2 H.
You have the following options for the one-cable solution:
DOCS
SCD2A-H
After you have confirmed
remote control, set your reception
A/ V buttons to navigate to IF Channel.
select your assigned
to navigate to Centre
assigned frequency.
search and use the
perform a network search (NIT) or not (If you have selected ON, a list is
loaded from the satellite where new transponders
use the A/ V buttons to navigate to Search
buttons to select which programs are to be searched for and saved. To
start the search, exit the right menu with the EXIT button on your remote
control. If you want to accept the pre-saved
by pressing the EXIT button several times. If you want to start a NEW
search, use the A/ V buttons to select the satellite on which you want
to carry out a search. Press the BLUE BUTTON
control to start the
Easyfind funktion
If you have an Easyfind antenna or an Easyfind LNB, activate the
Easyfind function to align your antenna. To do this, press the MENU
button on your remote control. Navigate with the buttons A / V to the
menu item Installation
0K button. Now use the A / V buttons to navigate to the menu item
Easy Find and confirm your selection by pressing the 0K button. Now
activate the Easyfind function by using the < /
"Yes" and confirm your selection
align your antenna. As soon as the Easyfind function has been activated,
the LNB receives the corresponding
strength using the LED on the LNB. To deactivate
the Easyfind "No" menu item after setting up your antenna.
C, UNICABLE
1-8 User
I
1-32 User
your selection with the 0K button on your
IF Channel (User ID). Now use the A/ V buttons
Freq. Use the
Now use the A/ V buttons to navigate to Network
buttons to choose whether you want to
search.
and confirm your selection
D, SCD2 A, SCD2 B,
(UNICABLE
(UNICABLE2-EN
parameters in the menu. Use the
Use the
buttons to select your
Mode and use the
program list, leave the menu
(
by pressing the 0K button. Use it to
signals and shows the signal
27
A,
-EN 50494)
50607)
buttons to
are inserted ). Now
) on your remote
by pressing the
buttons to select
this function, select