Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Motorised
System
Network
Search
Scan
Mode
To start the search, exit the right menu with the EXIT button on your
remote
control.
Now
which you want to carry out a search. Press the BLUE BUTTON
on your remote control to start the search.
Attention:
All previously
Installation
(Antenna
With a single-cable
SOLOUTION)
you have to assign a corresponding
band) and the Center
should be familiar with these parameters
installer of your antenna system if you do not know these parameters.
To program these parameters,
button on your remote control and use the A / V buttons to navigate to
the Installation
button. Now use the A / V buttons to navigate to the Antenna
menu item. Confirm the menu item by pressing the 0K button. You can
now use the A / V buttons to select your desired satellite. Press the
button to go to the right side.
Use
the
A / V
buttons
navigate to the LNB Freq.
menu
item
and
confirm
with
the
0K
button.
The
selection
menu
here opens.
If you have a motorized
< /
buttons to select your control system.
Use < /
to select whether you want to perform
a network search (NIT) or not (if you have selected
ON, a list is loaded from the satellite
transponder
are inserted).
Use < /
to select what programs you will search.
use
the
A / V
saved programs
setting
satellite
system DOCS (DIGITAL-ONE-CABLE.
Freq (user band frequency)
proceed as follows: Press the MENU
menu item. Confirm the menu item by pressing the 0K
to
this
shown
rotating system, use the
buttons
to select
will be deleted!
I Digital one cable solution)
to your receiver. You
before the installation.
9750/10750
9750/10700
05150
D
05750
5150/5750
26
where
new
the
satellite
on
(
IF-Channel
(user
Ask the
setting
nrversa
8V
Werbung
