ODOUR OFF TELESCOPIC NAPPY BIN
odour-proof container for dirty diapers
COMPONENTS
A - Lid
B - Rotating cap
C - Cap holder
D - Bag holder
E1 - Outer cylinder (upper)
E2 - Inner cylinder (lower)
F - Handle
BEFORE USE: PRODUCT ASSEMBLY
Fig. 2a
Fig. 2b
1. After removing the rst plastic bag, unscrew the gray bag holder ring (D) counterclockwise
(Fig. 2a) to extract the other underlying components and remove the other plastic bags. The
lid in the package is pre-assembled and consists of multiple parts: a lid (A) with handle (F); a
rotating cap (B); and a cap holder (C). See Fig. 1.
2. Insert the smaller cylinder (E2) into the larger one (E1) and place the assembly on the oor. Lift
the outer cylinder (E1) completely until it reaches the end of its stroke. See Fig. 2b.
3. Holding the lower cylinder (E2) steady between your feet, carefully screw the outer cylinder
(E1, upper) onto the inner one (E2, lower), ensuring that the three internal grooves are aligned
and perfectly overlapped. See Fig. 2c. If done correctly, the diaper pail body should be upright
and stable. See Fig. 2d.
4. Screw the gray bag holder ring (D) onto the bin (Fig. 2e) and then screw the pre-assembled
lid (A+B+C) onto it clockwise until you hear the typical "click" at the end of the stroke (Fig. 2f ).
This is the signal that the assembly has been completed correctly.
5. Rotate the handle (F) to the "ready-to-use" position, with the diaper disposal cavity facing
upwards. See Fig. 2g.
INSERTION OF THE BAG
Fig. 3a
Fig. 3b
1. To insert a new bag, separate the lid with handle (A+B+C) from the gray bag holder ring (D)
underneath: hold the gray bag holder ring steady with one hand, while with the other hand,
lift the lid handle vertically and rotate it counterclockwise to unscrew it. See Fig. 3a.
2. The gray bag holder ring remains attached to the bin. See Fig. 3b.
3. Insert a 20-30 liter plastic bag into the central cavity, folding its ends into the three oval groo-
Fig. 2c
Fig. 2d
Fig. 3c
Fig. 3d
10
Fig. 2e
Fig. 2f
Fig. 3e
Fig. 3f
Fig. 2g