Werbung
Verfügbare Sprachen
Verfügbare Sprachen
WICKING
- Gently pull the cotton through the coil.
- Trim both ends of the cotton flush with the base.
- Place the cotton in the designated cotton wells of the deck. Ensure that the
cotton just touches the bottom of the deck but is not stuffed into the wells.
The edge of the deck should remain free of cotton.
- The coil is now ideally positioned in the airflow, ensuring optimal compression.
For more throat hit or less compression, the coil can be placed slightly lower.
20 English
FILLING THE TANK
NOTE:
The spare parts kit includes both 15*1 and 16*1 O-rings. With the 15*1 O-rings,
the liquid control is very smooth; with the 16*1 O-rings, it is tighter.
If 2x 15*1 O-rings are too smooth and 2x 16*1 O-rings are too tight, you can
also install one 15*1 (top) and one 16*1 O-ring (bottom) on the base.
- Turn the top cap counterclockwise to close
the liquid flow and open the top cap.
You can now remove the top cap and
fill the tank through the two slots above
the tank.
- By turning the top cap clockwise,
it will close, and the liquid control will open.
Your atomizer is now ready for use.
- For transport, you can close the liquid
control by turning the tank
counterclockwise and reopen it by
turning it clockwise after transport.
English
21
Werbung
