PRACTIXX PX-RRM-2000WI Bedienungs- Und Sicherheitshinweise Seite 47

E2 Wheel motor blocked
E3 Cutter disc blocked
Obstacle
E4 sensor trigger not
reset
E5 The mower was lifted
Roll-over sensor was
E6
triggered
Inclination sensors
E7
were triggered
Docking/recharging
E8
failed
The robotic lawnmow-
E9
er is stuck
Protection of the
E10
battery
E11 No boundary signal
Charging current too
E13
high or too low
The cutting area lies
E14
outside the boundary
40 | GB
1. Switch the mower off. Move the mower to an area that is free of obstacles.
Press the "START" button and then the "OK" button.
2. If the error message is still displayed, switch off the product. Turn the mow-
er upside down and check what is preventing the wheels from turning.
3. Remove the objects blocking the wheel(s), turn the mower over.
4. Press the "START" button and then the "OK" button.
1. Switch the mower off.
2. Turn the mower upside down and check what is preventing the blades
from turning.
3. Remove the objects and turn the mower over.
4. Place the mower in an area with short grass.
5. Press the "START" button and then the "OK" button.
1. If the error still occurs, contact your specialist dealer.
1. Switch the mower off.
2. Move the mower to an area that is free of obstacles. Press the "START"
button and then the "OK" button.
3. If the error message is still displayed, switch off the product. Turn the mow-
er upside down and check if there is anything preventing the front axle
from moving.
4. Remove all obstacles, turn the mower over and switch it on. Press the
"START" button and then the "OK" button.
1. Position the mower.
2. Press the "START" button and then the "OK" button.
1. Switch the mower off.
2. Move the mower to an area in your lawn with level ground.
3. Switch the mower on. Press the "START" button and then the "OK" button.
1. Check that there is 1 metre of space before and after the charging station,
without obstacles or corners.
2. The charging station must be placed on level ground.
3. Manually place the mower in the charging station for charging. After the
mower is fully charged, press the "START" and then the "OK" button.
1. Place the robotic lawnmower in an area that is free of obstacles.
2. If the error still occurs, contact your specialist dealer.
1. If the temperature is too high, wait until the temperature has dropped. If
the temperature is too low, wait until the temperature is above 5 degrees
Celsius.
2. If the error message is still displayed, replace the battery. Re-start the
mower. Press START and then OK.
3. If the error still occurs, contact your specialist dealer.
1. When the mower is in the working area, check the charging station LED
indicator. If it lights up red, make sure that the boundary wires are well
connected to the terminals on the charging station. If the problem persists,
check whether the boundary wires have been cut.
1. Check docking area.
2. If the error still occurs, contact your specialist dealer.
1. Switch the mower off.
2. Change the boundary lines/reduce the mowing area to the specified area.
3. Switch the mower on. Press "START" and then "OK".
www.practixx.com