BUTURE Beta06 Schnellstartanleitung Seite 9

Insert the jumper cable into the jump starter (20% power at least).
1
Connect the clamps to car battery (red to +, black to -).
2
Start your car engine.
3
· ABOUT THE FORCE START FUNCTION
If three attempts fail when the clamps correctly connected to your car,
you can use the Force Start Function to enter boost mode.
3 steps to fix the problem:
Check the clamps connection and the product's battery is above 20%.
1
Press the Force Start Button for 3 seconds.
2
The indicator will be green, and go back to start engine ignition.
3
Caution:
When using this function, auto-detection and safety features will
be disabled temporarily.
8.TROUBLESHOOTING ABOUT CLAMPS
In any of the following situations, the smart clamp will turn protections on:
Indicator
Flashing red and green
Solid green
Standby status
Ready to start
EN 07
Situations
START
/STOP