Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Manuel
EN
Remote Control Instructions
Note: Built-in temperature probe. don't lose this thermostat!
12
11
10
1
9
2
3
8
4
7
5
6
When there is no remote control. Pay attention to the following special circumstances.
- When the product is plugged in for the first time and the remote control is not
detected, the product displays "00". the ambient temperature will be displayed 0
degrees.display default 25 degree operation.The product is always in heating state.
- When the remote control is detected after the product is turned on (The remote
control has been operated), the product displays the ambient temperature detected
by the remote control.
- When the product is always plugged in and the remote control has been detected, and the
remote control is out of power or broken during subsequent use, or cannot be found. The
product displays the ambient temperature last detected by the remote control.
Remote control
1. Temperture display
2. Day of week
3. On / off
4. Set
5. Week program
6. Setting for temperture
7. Temperature decrease
Weekday decrease
Hour and minute decrease
Illumination decrease
8. Temperature increase
Weekday increase
Hour and minute increase
Illumination increase
9. Hour / minute
10. Heat
11. Week program set
12. Degrees
As long as the set temperature is higher than the ambient temperature last detected
by the remote control, the product can be used normally.
- Short-press remote control
,If the target temperature is higher than the ambient
temperature, the product will automatically heat, and the product heating indicator
will light up.
- Set operating temperature press
or
50 ° C, flashing 3 seconds,if no further operation, return to display the ambient
temperature. When the ambient temperature is 1 degree lower than the target
temperature, the product is automatically heated
temperature reaches the target temperature, the product automatically stops
heating.
Before we set the weekly timer we need to set the current time first
In on mode press button first time HOUR icon flashing,press
again to confirm. Then MIN icon flashing,press
HOUR press
again to confirm. Then WEEK icon flashing, press
MIN press
again to confirm.
week day, press
How to set the weekly timer
1. In off mode press
,then week icon flashing press
again to confirm.
press
Then "P1" flashing, press
to confirm.
Start to set ON time,ON icon display,
HOUR icon flashing press
or
to set HOUR, press
Then MIN icon flashing press
or
to set MIN press
Start to set OFF time,OFF display,
HOUR icon flashing Press
or
to set hour press
Then MIN icon flashing press
or
to set MIN press
In the same way, set the daily ON time and OFF of P2,P3, and P4. Users can set
different on and off every day in P1, P2, P3, P4.
2. After setting weekly timer, In OFF Mode, press
starts or shuts down at a set time. Display showing
FlinQ Smart Indoor Hybrid Heater
for setting temperature.can set 05-
Light on. When the ambient
or
to set current
or
to set current
or
to set current
or
to set current week day
again to confirm.
again to confirm.
again to confirm.
again to confirm.
and then press
, The product
and
.
Werbung
