Antlion Audio ModMic Uni 2 Bedienungsanleitung

ModMic Uni 2 Installation
Parts List
One
ModMic Uni 2
Surface Selection
Find a flat spot on the headphones for the 0.5 inch/12.7mm circle of adhesive. The adhesive will stick to smooth and
mesh surfaces but does not stick well to porous, lacquered, or rubberized surfaces.
1. Put the headphones on to ensure the ModMic will reach the corner of your mouth from the desired mounting point.
2. Thoroughly clean and dry the surface with the included alcohol pad.
Attaching & Orientation
1. Attach a to the
2. Remove the protective backing from the adhesive.
3. While holding the
so it points towards where your mouth will be when using
your headphones. (This will reduce the need for additional
bends in the boom after installation—see Figure A).
4. Press the whole mic/clasp down onto the cleaned spot
and hold firmly for 60 seconds
to cure for 1 hour
In-line Carrying case &
mute switch instruction manual
that holds the ModMic's boom.
orient the mic boom angle down
. Allow the adhesive
.
One alcohol Two base clasps, one
wipe top clasp with cap &
extra 3M adhesives
A
5x
One foam
pop filter