Seite 2
Herstellers führen. Für The creator is grateful for suggestions for im- Verbesserungsvorschläge Ersteller provement. dankbar. Ersteller: Creator: Polytron-Vertrieb GmbH Polytron-Vertrieb GmbH Postfach 10 02 33 Postfach 10 02 33 75313 Bad Wildbad 75313 Bad Wildbad Germany Germany...
Beschreibung Description Bei den Modulen SPM-PS/ Crypto- The modules SPM-PS/ CryptoWorks/ Works/ Conax, SPM-PST/ Crypto- Conax, SPM-PST/ CryptoWorks/ Works/ Conax und SPM-PSI handelt Conax and SPM-PSI are DVB-S re- es sich um DVB-S-Empfangsmodule ception modules for the conversion of zur Umsetzung von QPSK modulier- QPSK modulated programs into AV ten Programmen in AV-Signale.
↔ ein/on aus/off Bild 1 Schalter für LNB-Spannung Figure 1 Switch for LNB voltage Bei Bedarf lässt sich die LNB- If necessary the LNB voltage can be Spannung durch einen auf dem Mo- switched on or off, by a switch (Fig- dul befindlichen Schalter (Bild1/1) ure 1/1) present at the module.
Bild 3 Anschlüsse am Figure 3 Connections of the module SPM-PST-Modul SPM-PST Bei den Modulen SPM-PS/ Crypto In the modules SPM-PS/ Crypto- Works/ Conax und SPM-PSI ist nur Works/ Conax and SPM-PSI only der Ausgang A vorhanden. output A is available.
2.2 Kartenaufnahmen der Module 2.2 Card slots of the modules Bild 4 Kartenleser SPM-PST Cryp- Figure 4 Card reader SPM-PST toWorks/ Conax CryptoWorks/ Conax Smart-Card mit dem Kontaktfeld in Plug Smart-Card in with the contact Richtung Platine einstecken. bank in the direction of the circuit board.
Programmierung der Programming procedure Module for the modules Nach der Bestückung der Grundein- After the assembly of the basic unit heit und dem Aufbau der Eingangs- and the construction of the entrance verteilung erfolgt zunächst die Pro- distribution, the basic unit and the grammierung der Grundeinheit und modulators have to be programmed der Modulatoren gemäß...
Seite 8
Softwareversion zur fehlerfreien programming, is specified on Programmierung der Module, the module and can be seen in ist auf dem Modul angegeben software matrix und kann der Softwarematrix www.polytron.de Service unter www.polytron.de Ser- Software. vice Software entnommen werden.
Seite 12
3.2 Programmierung SPM 1000 digi / Programming SPM 1000 digi gedrückt halten bis Anzeige ak- Modulsteckplatz wählen tiviert ist select modul slot keep pressed until display is activated Polytron Headend ←PL01 SPM-PST→ Program → Service SPM1000 DIGI X.X. ↨ ↨ PL02 SPM-MMT...
Seite 13
Eingangsfrequenz Symbolrate / Symbol rate Input Frequency 02001 …27500 KSym 920 … 2150 MHz Set Input Symbol Input Frequency ↨ 26999 KSym → 1550 MHz → ↨ Auswahl der Ziffernstelle durch Bewe- Auswahl der Ziffernstelle durch Bewe- gung des Cursors und Auswahl des Wertes gung des Cursors und Auswahl des Wertes durch durch...