Alarm Test - Rodger Bas Produkt Information, Gebrauchsanleitung, Garantie

Installa on bedwe ng alarm
• Put the ba ery in the transmi er.
• Place the plug in the receiver.
• Plug the receiver into an electrical outlet and switch it on by pressing the central LED
bu on (A), which will light up green.

Alarm test:

• Make sure that the receiver is switched on and volume is adjusted (+ bu on (C)).
• Connect the two push-bu ons of the transmi er with the metal strip (F) on the
receiver. This will cause the alarm to sound and the LED (A) will start blinking red.
• The alarm can be turned off by pushing the central LED bu on (A).
Pairing the transmi er and receiver:
• Plug the receiver into an electrical outlet and switch it on by pressing the central LED
bu on (A), which will light up green.
• Press the – and + bu ons (B + C) simultaneously for 3 seconds.
• The central LED bu on (A) will start blinking green: within 1 minute you have to
connect the two push-bu ons of the transmi er with the metal strip (F) of the
receiver. The transmi er and receiver are paired when the LED lights up green and
the receiver gives a sound.
Extra receivers can be paired with the transmi er in the same way.
Se ng alarm sounds:
| For each alarm to make the same sound:
Select the sound of your choice by pressing the SELECT- bu on (D). The last selected
sound will be heard every me the alarm goes off .
To test the sound, connect the two push-bu ons of the transmi er with the metal
strip (F) of the receiver. This will cause the alarm to sound and the LED (A) will start
blinking red.
| For each alarm to make a diff erent sound:
Press the AUTO-bu on (E). With each alarm 1 of the 8 available sounds will be heard.
| Range:
The range of the receiver and the transmi er is maximum 30 meters (100 feet) in open
air. Inside buildings, the range could be less than 30 meters (100 feet).
nual BAS.indb 3 nual BAS.indb 3
UK
3
25-11-2011 16:19:5 25-11-2011 16:19:5