Brock BVC 5002 RD Bedienungsanleitung Seite 15

• Rinse filter in lukewarm water and dry the filter completely.(fig.5&6)
• Always operate the cleaners with filters installed to avoid reduced suction
• Disconnect from electrical outlet before cleaning filters.
REPLACING THE MOTOR FILTER
• Pull dust bag upward and remove the motor protection filter.(fig.7)
• Put a new motor filter into the cleaner and close the front cover.
REPLACING THE EXHAUST FILTER
Open the filter grill to remove the exhaust filter.
• Take off the filters from the grill.
• Put a new filter back on to the filter grill.(fig.8)
• Close the filter grill.
TROUBLESHOOTING
The motor will
☆The power cord is not
not start.
connected correctly to the
wall power outlet.
☆The wall power socket is
damaged.
☆ The vacuum cleaner is
not switched on.
The suction
☆ The dust bag is
output is weak.
completely full.
☆ The vacuum cleaner is
clogged.
☆The filter is clogged.
The power cord The power cord may have
is not wound in slipped down from the
☆ Insert the plug firmly into
the power socket.
☆Inspect the power socket.
☆Turn on the vacuum cleaner.
☆ Change the dust bag
☆ Remove the blockage or
foreign object
☆ Clean the filter.
Hold the cable under tension
while winding the cable.
GB