Brock BVC 5002 RD Bedienungsanleitung Seite 14

GB
• Connect the crevice tool ,dusting brush or small nozzle (specific models only) directly to the
hand grip or to the tube.
- The crevice tool can be used either for cleaning narrow comes or hard –to-reach places.
- The dusting brush can be used for cleaning computers, bookshelves etc.
- The small nozzle can be used for vacuum cleaning small areas,e.g.the seats of chairs and sofas.
INSTRUCTIONS FOR USE
• Before operating the vacuum cleaner, make certain that the filters are in the proper position.
•Unwind a sufficient length of cable and insert the plug into the power socket, A YELLOW mark
on the power cable shows the ideal cable length. Do net extend the cable beyond the RED mark.
• Press the ON/OFF button to switch the appliance on .It is advisable to set the power control to
MIN before switching on the appliance.
• To rewind the power cable, press the rewind button with your foot ,and guide the cable with
your hand to ensure that it does not whip causing damage.
• By moving the variable power control (not available on all models),the suction power can be
adjusted to suit different types of flooring i.e. MIN setting for vacuuming light rugs.
• Adjust the suction regulator on the handgrip to control the suction. The suction will be reduced
with a larger air opening.(fig.4).
MAINTENANCE
REPLACING THE DUST BAG
• Always operate the cleaner with the dust bag installed.
• If you forget to attach the dust bag or attach it in the wrong manner, the dust cover may not
close completely.
• After removing the flexible hose, open the front cover using the compartment open button.
• Remove the dust bag and insert a new one.
• Close the cover by pressing down until it clicks.
REPLACING THE FILTERS
• If there is dirt found on the filter , it should be washed and cleaned at once. Normally, it's should
be washed after using more than 50 hours.