LD Systems ANNY 10 BATTERY Schnellstartanleitung Seite 3

QUICK START GUIDE
This symbol indicates that the product has no ser-
viceable parts. Only authorized personnel is al-
lowed to perform maintenance or service work.
This symbol indicates helpful hints or additional in-
formation.
3.3 GENERAL SAFETY
• Read this user manual carefully.
• Keep this user manual for later reference.
• Follow closely the instructions in this user
manual.
• This user manual is an integral part of the
product. If you sell or pass on the product, you
must include this user manual.
• Only use this device according to its intended
use.
• This device is for professional use only.
• Observe all safety instructions and warning mes-
sages in this user manual, on the device, and on
the packaging.
• Devices are subject to continuous further devel-
opment. If you find discrepancies between the
user manual and the device labeling, the inform-
ation on the device always takes priority.
• Do not remove safety instructions or warning
messages from the device.
• Do not open the device.
• Do not modify the device.
• If the device shows any sign of damage, do not
use it.
• Do not operate the device with removed or miss-
ing covers.
• Do not expose the device to direct sunlight.
• If not further specified in the user manual under
Technical Data, do not use the device in ambient
temperatures that exceed 40°C / 104°F or fall
below -5°C / 23°.
• Do not use the device in tropical climate.
• Do not use the device above 2000m of altitude.
LD ANNY 10 BATTERY QSG
• Unless otherwise stated, do not use under mar-
ine conditions.
• Use only accessories specified by the manufac-
turer.
• Maintenance and repairs may only be carried
out by authorized service personnel.
• Store and transport the device in a dry and safe
environment.
• If the device was exposed to strong temperature
changes, such as during transport, do not switch
it on immediately. Wait until the device has
reached ambient temperature.
3.4 ELECTRICAL SAFETY
• Do not bypass the mains fuse.
• Use only mains fuses as specified by the manu-
facturer.
• Do not use kinked or otherwise damaged power
cables.
• Only operate the device on compliant, tested
and intact mains power outlets.
• Make sure that the voltage and frequency of the
mains power match the values specified by the
manufacturer.
• Take suitable measures against overvoltage,
such as lightning strikes.
• For devices with a power out connector, make
sure the total current consumption of all con-
nected devices does not exceed the value spe-
cified by the manufacturer.
• This device is not suitable for continuous cur-
rent.
• Disconnect the device from all poles before
maintenance, repair or extend periods of non-
use.
• Permanently connected power cables may only
be replaced by a qualified service technician.
3.5 BATTERY SAFETY
Risk of fire, explosion or outgassing. The following
safety instructions must be observed.
GENERAL
3