Control Module; Possible Cause; Additional Information - Tectake 405083 Bedienungsanleitung

Control module

See: fig. 13.
a.speed control knob
b.play music/change volume
c. add rocking time
d. shorten rocking time
e. charging port
Speed control knob - lets you make the chair move constantly and soothingly.You can choose
five speed levels, as marked in the knob. To switch it off. Turn the knob in the initial position,
marked as ,O". The product will stop rocking yet the music will not be stopped.
Play music/change volume - press this key to play music. At first the volume is minimum. Press
the key again to volume up. To stop playing music, press this key three times.
Add/shorten rocking time - this option lets you schedule product shutdown.You can choose the
following time settings: 15, 30, 45 minutes. lf you do not use any time (none of three LEDs glows),
the device will switch off automatically after 60 minutes.
If the product does not work properly(e.g. rocking power is too low, distorted music,dim light signs),
it may mean the battery must be replaced.
How to store and transport the product
To fold the product (fg. 14):
1.Lift both frames of the seat.
2.Disconnect the control module from the baby swing. frame and then lift it.
3.Connect the legs of the product.
4.Secure the product with an assembly belt located at the reverse of the covering (see: fig.15)
Troubleshooting
Problem
Light indicator
flashes
Rocking stops
suddenly.
Rocking does
not start

Possible cause

Low batteries
or damage to
feeder cable.
Set time has passed.
Batteries have
been inserted in a
wrong way.
Damage to the
feeder cable.
Feeder cable has
been connected in a
wrong way.
No power supply in
the socket
Solution
Replace battery
or adapter.
Deactivate rocking
with a knob and then
activate it again. Disable
rocking time setting.
Insert the batteries
again. Pay special
attention to marking
(poles).
Check the feeder cable
and wire for proper
connection.
Check if the feeder cable
has been plugged in the
socket properly.
7
Additional
information
Each of these solutions
will cause the product
to resume working,
only the following will
change: work time and
rocking speed.